Tube Type Metal Detector

Tube Type Metal Detector

According to the diameter of the pipe and the type of material passing through, our production is carried out as a special production in the transportation systems made by means of pipes.

In pipe-type metal detectors, a flap that works pneumatically performs the process of ejecting a metal-containing product.
It has the same structure as the tunnel type metal detector.
The product structure and the material transition rate are important for detector sensitivity.

PRODUCT REJECTION SYSTEMS

They are air or mechanically operated systems that allow the metal product detected in metal detectors to be ejected. Or it is the system that performs the marking process, such as throwing paint on the faulty product that has been detected.

TECHNICAL SPECIFICATIONS

  • Supply voltage: 220V AC ±10%
  • Max power: 15W
  • Board: IP 65
  • Sensor: IP 65 MIN sheet metal
  • Sensor cable: LIYCY
  • Supply cable: 2 x 1.5 mm
  • Control relay: 10 Amp Inverter.
  • Warning relay: 6 Amp Inverter.
  • Fault relay: 6 Amp Inverter.
  • LCD digital display
  • Ability to set sensitivity and other settings by giving a numeric value (dec 0 to 250)
  • Interference adjustment (radio – cable, etc.) to reduce environmental effects to zero.(b)
  • Manual reset
  • Automatic reset (0 – 60 sec)
  • Delay adjustment (0 – 60 sec)
  • Product effect adjustment (0 – 60 sec)
  • The possibility of counting and resetting the metal signal on the LCD display
  • The electronic and mechanical components can work december the range of -20 C to +55 C.

    GET A QUOTE

    Fill out the form below to get any information you might have about the product! We’ll reach out to you as soon as possible.

    Tube Type Metal Detector